Deltech-fitness DF838- Stack Loaded Lat Attachment Instrukcja Użytkownika

ASSEMBLY INSTRUCTIONS FORTHE DF838 LAT ATTACHMENT*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FRE

ATTACH THE LAT ATTACHMENT TO THE POWER RACK OR SMITH MACHINE USING THEM12 x 75MM BOLTS (O), 4” FLANGE PLATES (I), M12 WASHERS (S) AND M12 LOCKNUTS(R).

WEIGHT STACK FRAME ASSEMBLYINSTALL THE RUBBER SHOES (J) 0NTO THE BOTTOM SUPPORT(AA). ATTACH THE BOTTOMSUPPORT (AA) TO THE LAT ATTACHMENT USING THE M12

WEIGHT STACK ASSEMBLYINSTALL THE RUBBER DOUGHNUTS (EE) ONTO THE BOTTOM OF THE CHROME RODS (GG) ,LEAVING APPROXIMATELY 2” PROTRUDING. INSERT THE CHROME

UPPER PULLEY ASSEMBLY INSTALLATIONREMOVE THE BOLTS, NUTS, AND WASHERS THAT HOLD THE UPPER PULLEY FRAMEASSEMBLY TO THE BODY.INSTALL THE UPPER PULLEY AS

INSTALL UPPER CABLE OVER FRONT PULLEY, BACK TO REAR PULLEY, DOWN TO TOPPULLEY OF FLOATING PULLEY ASSEMBLY, UP TO STACK ASSEMBLY PULLEY AND DOWNTO SELE

LOWER CABLE INSTALLATIONINSTALL LOWER CABLE UNDER FRONT PULLEY AND BACK TO REAR PULLEY. CONTINUEUP AND OVER LOWER PULLEY OF FLOATING PULLEY ASSEMBLY.

WARNING: THE USER OF THIS WEIGHT EQUIPMENT ASSUMES THE POSSIBILITY OF INJURY BYEXERCISING ON THIS EQUIPMENT. THE POSSIBILITY OF RISK CAN BE REDUCED BY

*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE (888) 258-0533DF830HARDWAREQTY 1DF830INSTRUCTIO

*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE (888) 258-0533DF830HARDWARERUBBER SHOEQTY 4J2”

*NOTE IF YOU ARE MISSING HARDWARE OR HAVE ANY FIT UP PROBLEMS PLEASE CONTACT DELTECH FITNESS TOLL FREE (888) 258-0533WEIGHT STACKCOMPONENTSUPPER PULLE

TOOLS REQUIRED:METRIC WRENCHES OR SOCKET SETINSTALL THE REAR SUPPORT (F) TO THE BOTTOM SUPPORT (B), ALIGNING HOLES INFLANGE WITH PIN AND THREADED STUD

INSTALL THE 3 1/2” PULLEYS (L) INTO THE FRAME USING THE M10 x 43MM BOLTS (U),THE M10 FLAT WASHERS (W), AND THE M10 LOCKNUTS(X).INSTALL THE RUBBER SHOE

INSTALL THE 3-1/2” PULLEYS (L) INTO THE TOP FRAME (A) USING THEPULLEY BUSHINGS (M), THE M10 x 75MM BOLTS (Q), AND THE M10 LOCKNUTS (W).NOW INSERT THE

INSTALL THE UPPER FRAME ASSEMBLY TO THE FRAME SUPPORTS WITH M12 x 65MMBOLTS (P), M12 WASHERS (S), AND M12 LOCKNUTS (R).FRAME ASSEMBLYPSSR

ASSEMBLE THE FLOATING PULLEY ASSEMBLY BY USING 3-1/2” PULLEYS (L),FLANGES (H), M10 x 43MM BOLTS (U), M10 WASHERS (W), AND M10 LOCKNUTS (X).WWXHULFLOAT